How to do the Maintenance for Aluminum Doors and Windows to extend the Life Span of Our Products?

With the rapid development of modern science and technology, people are demanding higher and higher quality of life. Nowadays, aluminium alloy doors and windows have gradually become the mainstream of the door and window industry for the city life and are favored by people.

Although the performance advantages of aluminium alloy doors and windows are outstanding, aluminium alloy doors and windows should be maintained from time to time to avoid quality damage so as to prolong the service life of the used aluminum doors and windows system. 

7 Tips for you,

01 For Aluminum Sliding Glass Door and Windows

When Aluminum alloy doors and windows are used, the action for sliding should be gentle. When difficulties to slide is found, pls do not pull and push it hard.  Dust residue and deformation are the main reasons. It is necessary to keep the door frame clean, especially for the push-pull groove. Vacuum cleaner can be used to remove the dust accumulated in the groove and door seals.

02 Attention on the Safety 

When cleaning the thermal break or non thermal break aluminium profile doors and windows, people should not step on the aluminium frame, nor pull the frame for support. It is easy to make the aluminum doors and windows to wear and even to cause accidents.

03 The Selection on Cleaning Agent

Soft cloth can be dipped in water or neutral detergent for Thermally Broken Aluminum doors and windows. Do not use ordinary soap and laundry detergent, or toilet cleaning detergent and other strong acid-base detergents.

04 Moisture-proof and Water-proof

After rainy days, wet glass in aluminum doors and window frames should be wiped out in time and special attention should be paid to wiping the water accumulated in the chute. The friction force shall be increased when the sliding groove has been used for a long time and a little oil or pyrotechnic oil can be added for daily maintenance.

05 Maintenance on Small Parts and Accessories

Aluminum alloy frame joint should be checked frequently, bolts should be tightened in time and damaged parts should be replaced. Aluminum alloy doors and windows, such as positioning pins, wind braces and floor springs, should be inspected regularly and lubricated is suggested to be added regularly to keep them clean and flexible.

06 About the Sealing Strips and the Glass Glue

Sealing strips and glass glue are the key structures to ensure the good sealing and insulation of doors and windows. If they fall off, pls make sure they are replaced by professionals in time.

07 Periodic Inspection

Aluminum alloy frame and wall joints are suggested to be checked for a long time. If loosened, it is easy to make the frame to be deformed as a whole. This caused the aluminum doors and windows not to be closed and sealed. Also if the screw are loose at the joint, they should be tightened immediately.